*** Buy one get one 30% off - offer applies to all single pullers and presses *** VAT-free prices outside the UK ***

Bottom Bracket Presses on Sale Now!

Posted by Jim MacPhail on

The new products are coming thick and fast just now!  This one is an obvious next step. We now have bearing presses for the most common bottom bracket bearings: 24x37x7mm, 25x37x7mm and 30x42x7mm.

These two bearing sizes are employed by many bottom bracket manufacturers, including Hope and others, often using the following references:

  • MR2437 (24mm ID bearing)
  • 6805 (25mm ID bearing)
  • 6806 (30mm ID bearing)

Installing bearings straight and accurately is important if you want your bearings to last.  It’s particularly critical for bottom bracket bearings; these bearings have a large diameter relative to the width and depth of the races, so are especially vulnerable to damage and premature wear due to misalignment of the races, or twisting during installation.

bottom bracket bearing press with t-bar handles

bottom bracket bearing press with t-bar handles 2

bottom bracket bearing press drift

The new presses are on sale here.

If you’re using a Hope press fit bottom bracket don’t forget to check out our hex keys for Hope PF bottom brackets too.

hope press fit bottom bracket pf41 pf46 tool hex


Leave a comment

Please note, comments must be approved before they are published